Extron electronic MTP 15HD Receiver Rear Panel Features, ATTENTION Potential damage to property

Receiver Rear Panel Features

Figure 6 shows an MTP RL 15HD RS receiver, which has all of the connectors and other features that are on either receiver in the MTP 15HD RS series.

5

MTP RL 15HD RS

BUFFERED

POWER INPUT OUTPUT

12V

.5A MAX

1 2 3

RS-232

Tx Rx G

OUTPUT

4

H SYNC + V SYNC + C SYNC SOG VIDEO END UNIT

ON

1 2 3 4 5 6

6

Figure 6. Receiver Rear Panel

APower connector — Plug the included external 12 VDC power supply into this 2-pole captive screw connector. Wire the connector as shown in figure 8 on page 12.

ATTENTION: Potential damage to property.

Before wiring the connector, read the notes, attentions, and warnings in the "Power Supply Wiring" section on page 12.

BInput connector — Connect one end of the twisted pair cable from the transmitter or from the buffered output connector of an RL receiver to this RJ-45 female connector.

CBuffered output connector — Connect one end of a twisted pair cable to this female RJ-45 connector. Connect the free end of the same TP cable from the receiver to the Input RJ-45 female connector on another receiver.

See "Twisted Pair Cable Termination" on page 13 to wire the RJ-45 connectors.

ATTENTION: Potential damage to property.

Do not connect these devices to a computer data or telecommunications network.

NOTES:

•The non-C7 transmitters and receivers will not work properly with STP201 or CAT 7 STP cable.

•The C7 transmitters and receivers will work properly only with STP201 or CAT 7 STP cable.

DOutput video connector — Connect a projector or other high resolution video device to this 15-pin HD connector.

ERS-232 connector — Connect a serial communications port to this 3.5 mm, 3-pole captive screw connector for bidirectional RS-232 communication. Wire the connector as shown in figure 5 on page 8.

NOTE: See D on page 8 before wiring the connector.

MTP 15HD RS Series • Installation and Operation 10