Extron electronic setup guide MTP 4T 15HD RS Setup Guide, Installation - Mounting, TP Cables

MTP 4T 15HD RS • Setup Guide

								:
					TANT complete
		IMPOR.com					for	the		and
									the
			on				instructions,
Goto		.extr
		,installationoreconnectingce
		www		bef			wersour		.
	guide
user					the	po
specifications
		product		to

This sheet provides quick start instructions for an experienced installer to set up and operate the MTP 4T 15HD RS multiple VGA video and RS-232 transmitters.

NOTE: Each MTP 4T 15HD RS transmitter requires at least one connected compatible MTP receiver. Additional receivers can be daisy chained.

Installation

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the unit as required.

Step 2 — Transmitter Inputs

•Connect a computer (VGA) video source to each Input connector.

•Connect a VGA monitor to each Monitor connector.

•Plug an RS-232 device into each RS-232 port. Wire the connectors as shown below.

Connected	Receive	Tx	MTP
RS-232	Transmit	Rx
			Pins
Device Pins	Ground	Gnd

RS-232

Tx Rx

INPUTMONITOR

Step 3 — TP Cables

Terminate up to four TP cables as shown below. Connect them between each transmitter’s Output port and a receiver’s Input port (both ends need to match).

	Pins:		T568A	T568B
12 3 4 5 6 7 8		Pin	Wire Color	Wire Color
		1	White-green	White-orange
		2	Green	Orange
		3	White-orange	White-green
		4	Blue	Blue
		5	White-blue	White-blue
		6	Orange	Green
Insert		7	White-brown	White-brown
		8	Brown	Brown
TP Wires

NOTE: If you are using Enhanced Skew-Free™ AV cable, use the TIA/EIA T568A standard only.