Setup Guide — P/2 DA4xi and P/2 DA6xi
Installation
The Extron P/2 DA4xi and P/2 DA6xi are distribution amplifiers taking one video input (VGA to QXGA) and distributing it to one buffered
Step 1
Ensure all devices are powered off or electrical cables are disconnected.
Step 2
Choose a suitable location and mount the distribution amplifier on a table, in a rack, or under a desk.
Step 3
Connect a computer source to the
Step 4
Connect four (P/2 DA4xi) or six (P/2 DA6xi)
NOutput 1, which is labeled “Local Monitor” is used for DDC reference.
Step 5
Power on the distribution amplifier.
Step 6
Power on the displays.
Step 7
Power on the source.
Troubleshooting
If the video output is “soft” on any display, move the video gain switch on the rear panel to the up (1V) position.
If no image appears:
•Check all the input and output video cables are connected and secure.
•Check all devices are receiving power.
•If the issue still persists, call the Extron support hotline.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500 +1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794 +1.919.863.1797 FAX
Extron Europe | Extron Asia | Extron Japan |
+800.3987.6673 | +800.7339.8766 | +81.3.3511.7655 |
Inside Europe Only | Inside Asia Only | +81.3.3511.7656 FAX |
+31.33.453.4040 | +65.6383.4400 |
|
+31.33.453.4050 FAX | +65.6383.4664 FAX |
|
|
|
|
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568 +86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800 +971.4.2991880 FAX
02 09