Epson Installation | Configuration and Connections |
|
|
|
|
Connecting System 4xi to Epson 8000/7250
[System
4
model and soft
ware
version
displayed
here] 
(See note.)
(See note.) |
(See note.)
(See note.) |
(Note: Information depends on System 4setup.)
If the System 4xi is already configured for an Epson 8000/7250 projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration.
1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Epson 8000/7250 projector. Apply power to the System 4xi and do the following:
a. Press 
to display the MENU SELECT on the LCD screen.
b. Press 
or 
to step to Menu 8.
c. Press |
|
|
|
| to select this menu. | |||
|
|
|
| |||||
|
|
| ||||||
|
|
|
|
|
|
|
| |
d. Press |
|
|
| or |
|
|
| to display the configuration. The example to the left is general, |
}yours will show the System 4xi model name, the software version and the following information:
PRJ = EPSON
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2.Go to the procedure on page
|
|
|
|
|
|
|
|
|
|
Config | Projector | SW1: | SW2 | SW3 | SW4 | SW5 | SW6 | Prj Cable | Comm |
as |
|
|
|
|
|
|
|
| Adapter |
|
|
|
|
|
|
|
|
|
|
| Epson 8000/7250 | 0 | 0 | 6 | E | 0 | J15 | ||
|
|
|
|
|
|
|
|
|
|
3.
4.Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
5.Connect the projector’s Comm cable (as shown) to the Com 1 DIN connector of the Epson projector.
Extron • System 4xi Switcher Series • User’s Manual • P/N | Page 4 |
