PMK 150 Installation Guide | Extron electronic instruction

PMK 150 • Installation Guide

The Extron® PMK 150 Pole Mount Kit is a simple solution for mounting Extron devices and their external power supplies to a projector pole.

Pipe

Clamp

PMK 150

Mounting Plate

The PMK can be installed on a 1½ inch pipe within a 4 inch space between the projector and the ceiling.

Including the power supply, the following devices can be mounted:

(2) Hex Bolts (2) Washers

(2) Tie Wraps

•one three-inch deep half-rack device, or

• two 3-inch deep quarter rack devices, or	Figure 1. PMK 150 Parts

•an MPA 401

CAUTION: The maximum load for the PMK 150 is 5 lbs (2.25 kg).

NOTE: The PMK 150 is to be used only with Extron UL listed products.

NOTE: Ensure the finished installation is in accordance with local and national

building codes, fire and safety codes, UL requirements, and local and

national electrical codes.

To install the PMK 150 (with a device) on a projector pole:

1.Place the plate on the base of the device and align holes in the plate with the mounting holes in the device (see figure 2).

2.Secure the device to the plate with 4-40 screws (see note below).

CAUTION: Use only the screws supplied with the device to avoid damaging it.

NOTE: When installing the MPA 401 onto

the PMK 150, install it with the rear

panel facing the projector pipe. Allow

enough space for the connectors on

the cables to fit without bending the

cables excessively. If the space for

this is inadequate, turn the MPA 401

around and place it on the PMK so the

front panel of the device is closest to

the pipe, and then connect the cables.

PMK 150

Use 2 mounting holes on opposite corners.