Installation
Extron’s Active Audio Buffering Unbalanced to Balanced Stereo Audio AAP Installation kit (part
Active Audio AAP Installation Kit Instructions
These instructions refer to both the RGB 138xi and the RGB 168xi models.
To install the Active Audio AAP Installation kit, refer to the steps below, the RGB 138xi, RGB 168xi User’s Manual, and the Active Audio AAP label wiring instructions.
Remove (12)
Screws
Lift Cover
Straight Up
| B 13 | 8 xi |
RG |
|
Remove #8 Screws (4 Places) Each Side and Bracket, if Present
1Disconnect the power from the interface, remove the interface from its rack mount or furniture mount position, and remove the top cover.
2Remove the blank AAP plate(s) from the interface to accommodate the
Active Audio AAP power cable connected to AAP power connector
Active Audio outputs
The Active Audio AAP plate’s power and audio connections must be wired before mounting the AAP plate in the interface. Both the provided Active Audio AAP power cable and the included captive screw audio connectors are keyed to prevent incorrect connections.
3Route the Active Audio power cable under the interface’s power cable.
Route the Active Audio AAP power cable under the interface's power supply cable
Connect this power connector to the interface's power connector
4Connect the interface end of the power cable to the power connector on the interface’s main board. The connectors are keyed to prevent an incorrect connection.
Connect the Active Audio AAP power cable to the interface's power connector
2 | RGB 138xi and 168xi Active Audio AAP • Installation | RGB 138xi and 168xi Active Audio AAP • Installation | 3 |
