Extron electronic RGB 168xi, RGB 138XI manual RGB 138xi, Active Audio AAP Installation Kit, Usa

5Route the audio cables through the rear cable clamp openings of the interface, as shown below.

Audio cables are routed through the rear cable clamp openings

Cable Routing

Connect powered speakers or another audio device to the included captive screw connectors. Insert the audio device wires into the captive screw connector and tighten the captive screws to fasten the wires, then insert the wired audio connector into the audio output connector of the Active Audio AAP plate before installing the AAP plate into the interface.

Connect the sleeve to ground (GND). Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

Unbalanced Output

Tip

See Warning

Sleeve (s)

Tip

See Warning

Balanced Output

Tip

Ring

Sleeve (s)

Tip

Ring

6Install the Active Audio AAP adapter into the interface using the four nuts and replace the interface’s top cover. Mount the interface in a rack or furniture and connect the power cords and turn on the devices in the following order: display and audio output devices, the interface, and input device (computer).

	Active Audio AAP Kit			Part number
	Active Audio Buffering Unbalanced to
	Balanced Stereo Audio Kit				70-110-04
		Extron Electronics, USA	Extron Electronics, Europe	Extron Electronics, Asia		Extron Electronics, Japan
		1230 South Lewis Street	Beeldschermweg 6C	135 Joo Seng Road, #04-01		Daisan DMJ Building 6F
		Anaheim, CA 92805	3821 AH Amersfoort	PM Industrial Building		3-9-1 Kudan Minami
		USA	The Netherlands	Singapore 368363		Chiyoda-ku, Tokyo 102-0074 Japan
www.extron.com		714.491.1500	+31.33.453.4040	+65.6383.4400		+81.3.3511.7655
		Fax 714.491.1517	Fax +31.33.453.4050	Fax +65.6383.4664		Fax +81.3.3511.7656

© 2001 Extron Electronics. All rights reserved.

User’s Guide

RGB 138xi and 168xi

Active Audio AAP Installation Kit

68-640-01 Rev. A

Printed in the USA

12 01