Extron electronic RGB 160 user manual Under desk mounting, Through desk mounting

Controls and Installation, cont’d

Under desk mounting

Mount the interface under a desk or in a podium, using an optional Extron MBU 125 Under-desk mount kit (part #70-077-01)as follows:

1.	Attach the mounting brackets to the interface using
	four machine screws supplied with the mounting kit
	(figure 2-6).

Figure 2-6 — Attaching the under desk brackets

2.	Using the not-to-scaletemplate at the back of this manual
	or the device with mounting brackets installed to guide
	you, mark the four screw holes on the underside of the
	surface to which you are mounting the interface.
3.	Drill four pilot holes, each 3/32" (2 mm) in diameter by
	1/4" (6 mm) deep, where marked.
4.	Using the four wood screws provided, attach the brackets
	under the mounting surface (figure 2-7).

Figure 2-7 — Securing the interface to the surface

2-6 RGB 160xi and RGB 164xi • Controls and Installation

Through desk mounting

Mount the interface through a desk or table, as follows:

1.	Attach the mounting brackets to the interface using four
	machine screws and washers (supplied with the mounting
	kit), as indicated in figure 2-8.

Figure 2-8 — Attaching the through desk brackets

2.	Using the not-to-scaletemplate at the back of this manual
	to guide you or the device with mounting brackets
	installed to guide you, mark the four screw holes on the
	underside of the surface to which you are mounting the
	interface.
3.	Cut the hole.
4.	Drill four pilot holes, each 3/32" (2 mm) in diameter by
	1/4" (6 mm) deep, where marked.
5.	Using the four wood screws provided, attach the brackets
	to the mounting surface.

RGB 160xi and 164xi • Controls and Installation 2-7