Contents
Legend of Icons
The following icons may be used in this manual:
___ Important information – for example, an action or a step that must be done before proceeding.
___ A Warning – possible dangerous voltage present.
___ A Warning – possible damage could occur.
_ A Note, a Hint, or a Tip that may be helpful.
__ Additional information may be referenced in another section, or in another document.
User’s Manual Part Number Information
RGB 202xi, 202 VTG, 202 VS2 and 202 VS SL2 User’s Manual
Rev. A,
Rev B,
Page
Rev C,
Updated specs on page
Update inside cover styles and manual part number.
Rev D,
Change output video range to 1.2.
Rev E,
Remote description.
Written and trinted in USA.
Accessing the Inside
Removing the RGB 202xi Cover
Jumpers are set at the factory to allow the RGB 202xi to detect most video requirements automatically. However, if it is necessary to change any of these jumpers you must first remove cover.
1.Turn power off by disconnecting the power cable.
2.Disconnect any other cables that may be in the way.
3.Use a small Phillips screwdriver to remove the four (4) screws inside each rubber foot. Put these aside.
4.Turn the case upright. The top half of the case is the cover. Pull upward on the cover to remove it.
5.Use the picture on the facing page locate the jumper that needs to be changed.
Configuration Jumpers
The general illustration here shows an example of a
Pins 1 and 2 – Press the jumper onto pins 1 and 2.
Pins 2 and 3 – put the open end of the jumper over pins 2 and 3 and press on.
No connections (Open) – This can be done any way, as long as no pins are connected. Three different Open connections are shown here. Connecting one side of the jumper and leaving the other contact off the end, or off the side, is a common way to do this. This way, the jumper is available if it is needed in the future.
Page ii | Extron • RGB 202xi Series • User’s Manual | Extron • RGB 202xi Series • User’s Manual | Page |