Extron electronic RGB 402, RGB 406 Two, Installation and Operation, Introduction, RGB 400 Series

Introduction

About This Manual

This manual contains information about the RGB 400 Series interfaces and on how to operate and configure them.

About The RGB 400 Series Interfaces

The RGB 400 Series are 300 MHz (-3dB) bandwidth, analog computer-video interfaces that can be mounted in walls or furniture. The RGB 400 and RGB 406 are two-gang wall plate size, the RGB 402 and RGB 404 are three-gang size, and the RGB 408 is four-gang size. All are available with black, white, or gray panels.

Features

RGB 400 Series features

Horizontal centering control — Shifts the image horizontally.

Level control — Adjusts the image brightness.

Peaking control — Adjusts the image sharpness.

Sync output options — Six BNC connectors allow separate horizontal, vertical and composite sync outputs. Sync-on-green (SOG) is output only if SOG is input.

Digital Display Sync Processing™ (DDSP™) — Sync is output in its original state to ensure compatibility with digital display products.

75 ohm video termination switch — For applications where a local computer monitor is not being used.

Additional RGB 402 and RGB 404 features

The RGB 402 and RGB 404 offer the following features in addition to the RGB 400 Series features listed above:

Composite video pass-through RCA connector

S-videopass-through4-pin mini DIN connector

Network pass-through (RJ-45 connector)

Left and right audio pass-through RCA connectors (RGB 402 only)

Two 2-channel audio outputs (unbalanced in, balanced out) on RCA and PC stereo connectors (RGB 404 only)

Additional RGB 406 and RGB 408 features

The RGB 406 and RGB 408 offer these features in addition to the RGB 400 Series features listed above:

Two channels of audio (unbalanced in, balanced out)

Optional pass-through adapter plates (RGB 408 only)

RGB 400 Series

Chapter2Two

Installation and Operation

Installation Overview

Installation and Operation Instructions

1-2 RGB 400 Series Introduction