Specifications — SW 4/6 AR MX HV Switchers
Video
Gain | Unity |
Bandwidth | 600 MHz |
Crosstalk | |
Switching speed | 5 mS (max.) |
Video input
Number/signal type | 4 or 6 (depending on the model) analog | |
| RsGsBs, component video, | |
| ||
Connectors | 4 or 6 x 5 BNC female (depending on the model) | |
Minimum/maximum levels | Analog | |
Impedance | 75 ohms |
|
Horizontal frequency | 15 kHz to 145 kHz | |
Vertical frequency | 30 Hz to 170 Hz | |
Return loss |
Video output
Number/signal type | 1 analog | |
| NTSC/PAL/SECAM composite video (same as input) | |
Connectors | 5 BNC female | |
Minimum/maximum levels | Analog | |
Impedance | 75 ohms |
|
Return loss | ||
DC offset | ±5mV maximum with input at 0 offset |
Sync
Input type | 4 or 6 analog RGBHV, RGBS, RGsB, RsGsBs |
Output type | 1 analog RGBHV, RGBS, RGsB, RsGsBs (same as input) |
Standards | NTSC, PAL, SECAM |
Input level | 0.5V to 5V |
Output level | Same as input |
Input impedance | 510 ohms |
Output impedance | 75 ohms |
Max. propagation delay | 40 nS |
Max. rise/fall time | 4 nS |
Polarity | Positive or negative |
Control/remote — switcher
Serial control port | ||
Baud rate and protocol | 9600, | |
Serial control pin configurations ... | 2 = TX, 3 = RX, 5 = GND |
|
Contact closure |
| |
Extron remote key pad control .. | Extron KP 10 keypad | connects to the |
IR controller module | Extron IR 101 | connects to the |
Loop signal | Momentary low, 1 mS min., 5 mS max. | |
Program control | Extron’s control program for Windows® | |
| Extron’s Simple Instruction Set™ – SIS™ |
General
Power | 100VAC to 240VAC, 50/60 Hz, 10 watts, internal, |
Temperature/humidity | Storage |
| Operating +32° to +122°F (0° to +50°C) / 10% to 90%, |
Rack mount | Yes, with optional 3U front panel |