Extron electronic TLP VIM manual Power Supply Wiring, Unbalanced Input, Balanced Input

POWER	INPUT
		VIDEO
12V
0.5A MAX	AUDIO

OUTPUT

DC Power Cord

Captive Screw

Connector

Ground

+12 VDC

Smooth	Ridges		Captive
A	A
			Screw
			Connector
		SECTION A–A
Power Supply			Tie Wrap
Output Cord

3"

16 (5 mm) Max.

External

Power Supply

(12 VDC, 1 A )

AC Power Cord

Figure 3. Power Supply Wiring

CAUTION: Always use a power supply supplied or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the

TLP VIM.

Extron power supplies are certified to UL/CSA 60950‑1 and are classified as LPS (limited power source). Use of a non‑LPS or unlisted power supply will void all regulatory compliance certification.

Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or in wall cavities. The power supply is to be located within the same vicinity as the Extron A/V processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack within the dedicated closet, podium or desk.

The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 75, and the Canadian Electrical Code, part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.

CAudio input –One 3-pole captive screw connector for inputting balanced or unbalanced audio. The audio input is mono only and either balanced or unbalanced.

Tip	Tip
	Ring
Sleeve	Sleeve

Unbalanced Input Balanced Input

Figure 4. Audio Input Connector Wiring

TLP VIM • Installation and Operation 5