VSC 75 Installation and Operation
VSC 75 Installation and Operation
Installation and Operation, cont’d
2-3
screws from the underside of the shelf, and securely
fasten them into diagonally-opposite corners as
shown in figure 2.
Figure 2 — Rack mounting
4. Attach the false front panel (provided with the rack
shelf) to the unoccupied side of the rack (as shown
above), or install a second half-rack-width device in
that side by repeating steps 1 – 3.
5. Attach the rack shelf to the rack using four 10-32 x ¾”
bolts (provided). Insert the bolts through #10 beveled
washers, then through the holes in the rack ears and
rack, as shown above.
Installation and Operation

Installation Overview

To install and set up the VSC 75, follow these basic steps:
1Turn all of the equipment off. Make sure that the
source computer, the VSC 75, and the output devices
(projector, monitors) are turned off and disconnected
from the power source.
2Mount the scan converter. See “Mounting the
VSC 75” on page 2-2.
3Set the rear panel toggle and DIP switches. See “Rear
Panel Features” on page 2-6.
4Attach the cables. See “Cabling” on page 2-7 and
“Rear Panel Features” on page 2-6.
5Connect power cords and turn on all the equipment.
6The image should now appear. If not, ensure that all
devices are plugged in and receiving power. Check
the cabling and rear panel switches, and make
adjustments as needed. Refer to “Troubleshooting”
on page 2-11 if needed.
7Optimize the image for your display environment.
See “Optimizing the Image” on page 2-10.

Mounting the VSC 75

Select tabletop placement or rack mounting. Follow the
appropriate installation instructions on these two pages.

Tabletop/desktop placement

For tabletop or desktop placement only, install the self-
adhesive rubber feet/pads (provided) onto the four corners
of the bottom of the enclosure.

Rack mounting

1. If feet were installed on the bottom of the VSC 75,
remove them.
2. Place the VSC 75 on one half of the 1U (one unit high,
one unit wide) rack shelf (part #60-190-01). Align the
front of the VSC 75 with the front of the shelf, and
align the threaded holes on the bottom of the VSC 75
with the holes in the rack shelf.
3. Attach the VSC 75 to the rack shelf with the two
provided 4-40 x 1/8” machine screws. Insert the
2-2
(2) 4-40 x 1/8" Screws
Use 2 mounting holes on
opposite corners
False front panel
uses 2 front holes
MIN/
MAX
FREEZE SIZE
TEST
FLICKER
FILTERI
II
VSC 75
SCAN CONVERTER
CENTERING/PAN SIZE