WPB 109 Wallplate • Installation Guide
The Extron WPB 109 wallplate is a single gang
Install the wallplate directly into the wall using the supplied mud ring or a
|
|
|
|
|
|
| : | |
|
|
|
|
| TANT | rthe | ||
|
|
|
|
|
| .com | fo | |
| IMPORon | ,installation | ||||||
|
|
| .e |
|
| |||
| to | www | xtr |
|
| . | ||
Go |
|
| specifications | |||||
| user | |||||||
|
|
|
| guide |
| |||
complete |
|
| and |
|
|
| ||
instructions, |
|
|
|
|
AUDIO
COMPUTER
HDMI
WPB 109
Front | Side | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Planning - Check the Proposed Installation Location
Before starting the installation it is important that you do the following:
WARNING: Failure to check these items may result in property damage, personal injury, |
or both. |
cEnsure there are no utility cables or pipes at the intended location that might be damaged or cause injury when you are installing the device.
cCheck that the installation meets the local and state regulatory requirements, including building, electrical, and safety codes, and UL and ADA accessibility requirements.
During installation ensure the space behind the device is sufficient for the bend radius of the pigtail. The recommended minimum bend radius is 2.4 inches.
Installation
1.Using the supplied mud ring or a junction box (not included) as a guide, mark and cut out the appropriate material within the marked area.
2. Either: | Locking Arms |
| |
zz Insert the mud ring into the opening, rotate the |
|
locking arms, and secure it with the supplied screws |
|
(as shown at right), or |
|
zz Insert the junction box and secure it with nails or |
|
screws. |
|
3.Run the cables (video, audio, and HDMI) from the output
or input device locations (as applicable), behind the wall, and to the WPB location, then thread the cables through the mud ring or junction box.
Wall Mounting Bracket
O
AUDI
COMPUTER |
I
HDM
4. Video — Insert the HDMI and VGA cable connector into | Extron |
the appropriate connector on the pigtail. | WPB 109 |
|
109
WPB
NOTE: If using a DVI display with the WPB 109, connect a |
number |
5. | Audio — Secure the output audio cable into the |
| described in “Cable Preparation for Audio Connections” on page 2. |
| NOTE: This may be easier to do before attaching the device to the mud ring. |
6. | Mount the cabled device into either the mud ring or the junction box. |
CONTINUED ON SIDE 2
1