WARRANTY & SERVICE
This rangehood carries a limited warranty against manufacturer's defects. To obtain warranty service, con- tact the dealer from whom you purchased the rangehood, or the local Faber distributor. If you cannot identify a local Faber distributor, contact us at (508)
WIRING DIAGRAM |
• This rangehood uses 20 watt Halogen Lamps.
FIGURE 9 |
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cook- ing vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel, located on the
0 | 1 | 0 | 1 | 0 | 1 | 2 |
L MV
FIGURE 8
Light On/Off Button ( L )
On/Off switch for the halogen light. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Set the blower speed control to "1" for LOW speed, "2" for MEDIUM speed and "3" for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Stainless steel cleaner should be used on stainless rangehoods. Abra- sives and scouring agents can scratch rangehood finishes and should not be used to clean finished surfaces.
Replacing the Halogen Lights
Before you begin, make sure that the rangehood is turned off and that the other lamps have had sufficient time to cool. Halogen bulbs burn extremely hot and serious injury could result from touching a hot bulb. To replace the halogen lamps shown in FIGURE 9, remove the two small screws located on both sides of the light. Remove the stainless steel trim ring aroung the light. Force the bulb out of the socket. Replace the lamp by inserting the new bulb into the socket. Replace the stainless steel trim.
Version
