Faber PRO MAGNUMw installation instructions Install the Rangehood

INSTALL THE RANGEHOOD

1.Remove the unit from the carton and place on a flat surface for assembly. Cover the surface to prevent accidental damage. Remove all parts including the mounting hardware before discarding the carton.

2.Remove the grease filters USING TWO HANDS (one to hold the filter so that it doesn't fall on cooktop and one to turn the knob) by pulling the knob out and turning to the left.

3.The rangehood is shipped from the factory in the up vent position as indicated in FIGURE 9. For top vent applications, no additional adjustments are necessary.

FIGURE 9

For rear vent applications, the blower must be turned inside the rangehood so that the blower vents to the rear as indicated in FIGURE 10. The blower is turned by removing two screws on each side of the blower, rotating the blower with the exhaust opening facing the rear and then replace the screws. The exhaustcovermustbemovedtoblocktheunusedopening. The blower must be converted before installing the rangehood.

FIGURE 10

4.Remove the cover from the field wiring compartment. Remove the wiring electrical knockout using a flat-blade screwdriver. Feed the Power Supply Cable through the electrical knockout.

5.The canopy attaches to the wall by two screws discussed earlier in the installation instructions. The canopy hangs from these screws by brackets inside the rangehood shown in FIGURE 11. Before attempting to hang the canopy, you should rotate the adjustment screw marked V1 in FIGURE

11counterclockwise to extend the brackets from the canopy. Using a Phillips head screwdriver, rotate this screw counterclockwise to extend the bracket.

FIGURE 11

6.Install the damper before hanging the rangehood. The damper attaches to the rangehood by two small screws provided in the hardware package. If 48" hood is to be connected to 10" round duct, install the Duct Transition Kit now.

7.Hang the rangehood canopy from the screws. Due to the weight of the canopy, these screws must be installed into solid material! Once the canopy is hung, rotate the screw marked V1 to secure the rangehood to the wall.

MAKE SURE THAT THE RANGEHOOD IS SECURELY ATTACHED TO THE WALL! FAILURE TO PROPERLY INSTALL COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.

8.The brackets shown in FIGURE 11 are also used to adjust the level of the canopy. Using a Phillips screwdriver, rotate the screw V2 to adjust the level of the canopy.

9.Connect the Power Supply Cable to the rangehood. Attach the White lead of the power supply to the White lead of the rangehood with a twist-on type wire connector. Attach the Black lead of the power supply to the Black lead of the rangehood with a twist-on type wire connector. Connect the Green ( Green and Yellow ) ground wire under the Green grounding screw.

10.Replace the field wiring compartment cover and the grease filters.

11.If the installation uses a telescopic chimney, connect the ductwork and install the chimney. Mount the upper chimney section to the wall first. Then mount the lower section. The lower section fits over the upper section.

If the installation uses a full width duct cover, install it now.

12.Turn the power supply on. Turn on blower and light. The rangehood controls are located on the right-hand side under the canopy. If the rangehood does not operate, check that the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connections have been made properly.

Version 12/04 - Page 6