PREPARATION
cC
ADJUSTING THE STEM
Follow these steps to adjust the metal detector’s stem.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to the desired angle. (The
1. If the detector is on, turn VOLUME(on the | z | If you do not plan to use the detector |
control housing) to OFF. (The control |
| for a week or more, remove the |
clicks.) |
| batteries. |
| z | Dispose of old batteries promptly and |
|
| properly. |
1.Turn the stem’s lock nut clockwise |
until it loosens. |
2.Lengthen or shorten the stem so when |
search coil should be parallel with the ground.) Tighten the knobs just enough to keep the search coil from rotating or wobbling.
2.Press on the battery compartment cover and slide the cover off in the direction of the arrow.
You can extend battery life by using earphones, which require less power than the
you stand upright with the detector in |
your hand, the search coil is level with |
and about 1/2 to 2 inches above the |
ground with your arm relaxed at your |
side. |
INSTALLING BATTERIES
You need six AA batteries to power your detector.
3.Insert the batteries into the compartment as indicated by the polarity symbols (+ and
TESTING THE BATTERIES
If the detector does not turn on, has weak volume, will not tune properly, or has erratic operation, or drifts, test the battery power.
Rotate VOLUME away from OFF and set OPERATE/BATT TEST to BATT TEST.
3.Turn the stem’s lock nut counter |
clockwise to lock it in place. |
Cautions:
zUse only fresh batteries of the required size and recommended type.
zDo not mix old and new batteries, different types of batteries (standard, alkaline, of rechargeable), or rechargeable batteries of different capacities.
de ele Prologo
Muchas gracias por su compra del produc
4. Replace the cover.
Cautions:
zAlways remove old or weak batteries; batteries can leak chemicals that can destroy electronic parts.
If the pointer on the view meter is between 3 and 6 (green area), the batteries have enough power to operate the detector. If the pointer is not in the green area, replace the batteries.
