CLEARING BLOCKAGES AND CLEANING THE AGITATOR ASSEMBLY
Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before clearing any blockages in the suction hose and cleaning the agitator assembly.
Clearing blockages
Clearing blockages in the suction hose A, B
1 Set the vacuum cleaner to the upright position.
Suction Inlet
Remove the hose cuff from the suction inlet and
2 then remove any blockages from the hose.
Hose Cuff
3 Reattach the hose cuff to the suction inlet, and then operate the vacuum cleaner to check that
the blockage has been properly cleared. If the hose is still blocked,the suction force will be weak.
Nozzle Pipe
Clearing blockages in the nozzle head
1 Remove the bottom plate(refer to page 14)
Nozzle Head
2 Remove any blockages from the nozzle pipe.
3 Reattach the bottom plate to the nozzle head, and then operate the vacuum cleaner
to check that the blockage has been properly cleared. If the nozzle head is still blocked, the suction force will be weak.
Caution: When the suction hose A, B or Nozzle head is blocked, the bypass valve will be opened automatically to protect the motor, resulting
in the suction force being reduced. The bypass valve will be at its original position automatically after the blockage is removed.
Bypass Valve (Inside)
Cleaning the agitator assembly
When threads get caught in the agitator assembly, clean the assembly.
Remove the bottom plate(refter to page 14).
Remove threads caught in the assembly by cutting them with scissors.
Scissors
Threads
12
