Fantom Vacuum FM625H owner manual On/Off Switch, Using The Unit With The Motorized Floor Brush

Fig. 15

Fig. 14

Fig. A

Wash once a month or when suction appears reduced

Warning: Allow 24 hours for drying before replacing in unit.

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

2.To separate the filter assembly, hold the bottom of the debris screen and pull the dust cup cover out. Then remove the HEPA filter with the filter ring from the debris screen (Fig. 13)

Filter Assembly

Dust Cup

Cover

HEPA

Filter

Filter

Ring

Debris Screen

Fig. 13

3.Once you have removed the HEPA filter from the debris screen, remove the filter ring from around the HEPA filter.

4.Vigorously “TapClean” the HEPA filter on a hard surface until no more dust is observed falling out. (Fig. 14)

The HEPA filter may also be washed by running it under

the tap allowing the water to run on the dirty side. (Fig. 15) We recommend washing it once a month or when suction appears reduced. Always allow 24 hours for air drying before replacing into the vacuum.

Warning: Never over fill the dust cup - remove dirt and clean the

HEPA dust cup filter, filter ring and debris screen each time the dust cup is emptied during prolonged usage or risk motor damage.

PLEASE NOTE: The white pleated filter material in the HEPA Filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. If the HEPA filter

is properly "TapCleaned” after each use and suction does not return to 100%, then we suggest that the HEPA filter be “TapCleaned” vigorously until no more dust can be removed,

then rinsed under the faucet and allowed to air dry for 24 hours before refitting into the vacuum. (Fig. A)

This should be done once a month or when suction appears to be reduced.

Note: Even though the HEPA filter is washable, it should be replaced every 3 to 6 months, depending on usage.

Warning: Always empty the dust cup container and clean the HEPA filter, filter ring and debris screen before each use and during prolonged usage.

Never over fill the dust cup container - remove dirt and clean the HEPA filter, filter ring and debris screen when dirt in dust cup is at or below the "MAX" level or during prolonged usage because you could risk damaging the motor.

If you wash the Hepa filter, make sure that it has completely air dried for 24 hours before inserting back into the vacuum.

Please Note: The HEPA Filter is washable. It should, however, be replaced every three (3) to six (6) months to ensure peak performance of your vacuum.

The filter ring and exhaust filter are also rinseable but they should be air dried for 24 hours before replacing into the vacuum. They should however be replaced every three (3) months to ensure peak performance of your vacuum. Important: Make sure that ALL filters are completely dry before re-installing back in the vacuum.

On/Off Switch

The On/Off switch has three different positions. (Fig.6)

•Push on the "I" side to turn the vacuum ON. Set the vacuum here when using the removable hose handle with the accessories or when vacuuming bare floors.

•Push on the “II" side to turn the motorized floor brush on.

•Push on the “O” side to turn the vacuum to the OFF position.

=OFF

= ON

(Bare Floors/Tools)

=ON (Carpet)

Fig. 6

Using The Unit With The Motorized Floor Brush

•Unwind the power cord and plug into the 120V outlet.

•Press the On/Off switch to the “II” position so that both the vacuum and the motorized floor brush is turned “ON”

NOTE: When vacuuming deep pile carpets or hard wood floors, lower the angle of the handle for easier maneuverability. (Fig. 7)

Fig. 7

Using The Unit With The

Accessories

•Remove the removable hose handle from

the hose connector.

•Attach the extension tube, crevice tool, the dusting brush, pet hair brush or air

driven turbo brush	Fig. 8
to the end of the
hose. (Fig. 8)

Manual Variable Suction Control

Your vacuum cleaner includes a variable suction control valve on the hose handle. The suction power can be adjusted by moving the slide to the desired position. For example. Less suction is required on upholstery and draperies compared to thick shag carpets, which require maximum suction.

Extension Tube

For hard to reach places. Use with crevice tool or with dusting brush.

Crevice Tool

For radiators, crevices, corners, baseboards and between cushions.

Dusting Brush

The dusting brush is used for the furniture, venetian blinds, books, lamp shades and shelves.

Pet Hair Removal Brush The pet hair removal brush is for use on upholstery, drapes and other fabric surfaces to remove lint, pet

hair, etc. THE PET HAIR REMOVAL

BRUSH IS NOT INTENDED TO BE USED AS A PET GROOMING DEVICE.

8

5