CLEARING BLOCKAGES AND CLEANING THE AGITATOR ASSEMBLY
Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before clearing any blockages in the suction hose and cleaning the agitator assembly.
Cleaning blockages in the suction hose A, B
1 Set the vacuum cleaner to the upright position. | Suction Hose A |
Remove the hose cuff from the suction inlet and |
|
2 then remove any blockages from the hose. | Hose Cuff |
Reattach the hose cuff to the suction inlet,and |
|
3 then operate the vacuum cleaner to check that |
|
the blockage has been properly cleared.If the hose | Suction Inlet |
is still blocked,the suction force will be weak. |
|
Cleaning blockages in the nozzle head
1 Remove the bottom plate(refer to page 14)
2 Remove any blockages from the nozzle head.
Nozzle Head
3 Reattach the bottom plate to the nozzle head, and then operate the vacuum cleaner
to check that the blockage has been properly cleared. If the nozzle head is still blocked, the suction force will be weak.
Cleaning the agitator assembly
When threads get caught in the agitator assembly, clean the assembly.
Remove the bottom plate(refter to page 14)
Remove threads caught in the assembly by cutting them with scissors.
Scissors
Threads
11