Fantom Vacuum VPW43H owner manual Getting to Know Your Pressure Washer Operating Instructions

GETTING TO KNOW YOUR PRESSURE WASHER

OPERATING INSTRUCTIONS

Storing Your Pressure Washer

When you have finished using your pressure washer, follow these steps for safe storage:

1.	Turn the pressure washer to the
2.	"Off" position.
	Turn off the water supply.
3.	Before disconnecting the high
	pressure hose connection, point the
	trigger gun in a safe direction away
	from you and discharge the high
	pressure water. Disconnect the high
	pressure hose from the pressure
	washer and trigger gun.

Ground Fault Circuit

Interrupter (GFCI)

This unit is equipped with a Ground Fault Circuit Interrupter (GFCI) built into the plug. This device provides additional protection from the risk of electrical shock. When connecting the GFCI to the electrical outlet, the indicator should appear red. If the indicator is not red, depress the RESET button on the GFCI until the indicator appears red.

Cleaning Tips

1516

7

1.Pressure Washer

2.Water Intake

3.High Pressure Output

4.On/Off Switch

5.Trolley

6.Trolley Handle

7.High Pressure Hose

8.Brush

9.Trigger Gun

10.Safety Lock

11.Trigger

109

12

11

8

13

14

12.High Pressure Hose Connector

13.High Pressure Lance

14.Adjustable Fan Jet Lance

15.Detergent Applicator Bottle

16.Garden Hose Coupling

17.Handle Bracket

18.Top Brace

19.Legs (x2)

20.Support Bracket (x2)

21.Wheel (x2)

22.Front Support

23.Trolley Screws (x11) (not shown)

4.	Disconnect garden hose from
5.	pressure washer.
	Remove excess water from the
	pump by tipping the unit on both
	sides to drain any remaining water
	from the water intake and outlet
6.	fittings.
	Drain detergent applicator bottle and
7.	flush with clean water.
	Wipe away any remaining water on
8.	all parts and fittings.
	Engage the trigger gun safety lock.
9.	Store the unit and accessories in a
	room above 32°F.

Winterizing & Long Term Storage

1.Disconnect all water connections.

2.Turn the pressure washer on for a few seconds, until any remaining water in the pump exits.

3.Turn the unit off immediately.

4.Store the pressure washer, parts and accessories in an area with a temperature above 32°F.

Motor Thermostat

Important: This pressure washer is equipped with a motor thermostat. The motor will stop if it is overheating. Wait 10-20 minutes before starting the unit again. If it stops again, please call FANTOM customer service at 1-800-798-7398.

Wood Decks: Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent applicator bottle and apply to the area being cleaned. For optimal results, reduce your work area to small sections and clean each section one at a time. Allow the detergent to rest on the surface for a few minutes and then rinse at high pressure. Do not let the detergent dry on the deck. Always clean from left to right and top to bottom for best results. Rinse at high pressure using the fan jet keeping the tip of the spray nozzle 8-12 inches from the surface. Caution: For soft woods, increase the distance from the cleaning surface.

Cars, Boats, & Motorcycles: Wet down area to be cleaned before applying detergent with clean water. Fill the detergent applicator bottle and apply to the area being cleaned. To achieve best results, clean one side at a time. Allow the detergent to rest on the surface for a few minutes but do not let it dry. Rinse at high pressure using the fan jet in a sweeping motion keeping the tip of the spray nozzle at least 8-10 inches away from the surface. Maintain a further distance when using a direct spray. Wipe surface for a polished finish.

Illustrations may differ from actual product. Technical Specifications

Voltage:	120V., 60Hz.
Power:	12.5 Amps.
Pressure:	1450 psi. (max)
Flow Rate:	1.45 gpm

3

8