ENGLISH
Model 2250C/2250S/2250M
Will shred:
2250C and 2250S: Paper, staples, paper clips, credit cards, CD/DVDs and junk mail.
2250M: Paper, paper clips, staples and credit cards.
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Strip-Cut ...........................................................................................5/32 in. (4mm)
Cross-Cut ........................................................5/32 in. x 1-9/16 in. (4mm x 40mm)
Micro-Cut .......................................................... 2/32 in. x 9/16 in. (2mm x 15mm)
*In order to perform at capacity, shredder must be plugged into a dedicated 15Amp,
120V outlet and oiled every 15-30 minutes of continuous use.
Maximum:
Paper entry width ............................................................................. 10.25”/260mm
* 8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 5.6Amps; heavier paper, humidity or other
than rated voltage may reduce capacity.
KEY
H. Control Panel and LEDs
1. ON/OFF (blue)
R
2. Reverse (red)
3. Bin full (yellow)
4. Door open (red)
5. Safety Shield Open (red)
A. Safety Shield
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Basket (inside)
F. Casters
G. See safety instructions
RRRR
R
R
R
R
RRRR
R
R
R
R
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Do not operate the machine without the safety shield closed (A).
• This shredder has a Disconnect Power Switch in the cabinet door. The door must
be fully closed to operate shredder. In case of emergency, open cabinet door. This
action will stop shredding immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
A.
B.
G.
H.
F.
C.
D.
E.
2
CAPABILITIES
15
15
15
15