Fellowes 30TM manual Before Binding, HOW to Bind, Need HELP?

BEFORE BINDING

1.	Ensure the machine is on a stable surface. Check	3.	Plug the machine into an easily accessible main
	there is enough clear space around the machine to		socket. Switch the main supply on.
	operate safely.	4.
2.			Open and lift the lid by releasing the safety catches
	Insert the power lead into the power socket (located		on the front of the lid.

at the rear of the machine).

HOW TO BIND

5. Switch the power on (located at the rear side).

6. The ‘Power-On’ button will be red. To activate the machine, press the ‘Power-On’ button on the control panel. The machine will warm-up, the red LED will flash. The machine will ‘beep’ (3x) and the LED turns green when the machine is ready to bind.

7. Prepare the documents by loading the sheets into the thermal covers. For best results, do not to place too many or too few sheets into the cover. Use the binding thickness scale as a guide. The guide is cali- brated in 6mm widths. Helios 30 will accept single or multiple documents up to a combined total thickness of 1.25” (approximately 300 sheets / 20lb).

8. The selected binding cycle is shown with blue LED. Use the timer selection buttons to navigate up or down the scale, if required. The scale has 10 settings. Eg: 0.25” document thickness = setting 1 (up to

60 sheets), 1.25” document = setting 10 (up to 300 sheets).

9. Pull open the document clamp (Heat-Shield fea- ture), insert the documents into the binding channel. Ensure the binding covers spine touches the heating element.

10. Start the binding cycle by pressing the ‘Select / OK’ button. The blue LED will start flashing and counting down, in sequence. When the cycle is complete, the machine will beep (3x). The blue LED will switch off.

11. The machine has an integral cooling tray. It can be extended from the back of the machine and can also be pulled upwards to accept larger documents.

12. When the binding cycle is complete, immediately remove the documents and place in the cooling tray or on a flat surface to allow the document to cool. The document can be removed from the machine mid-cycle if required, take care – the glue may be hot and melted.

NEED HELP?

Let our experts help you with a solution. Customer Service... www.fellowes.com

Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.

6