A.
B.
C.
D.
E.
F.
CAPABILITIES
G.
H.
ENGLISH
Model 99Ci
KEY
A. SafeSense® Technology | H. Control Panel and LEDs | 7. | Auto (blue) | |||||||||||
B. Paper entry |
| 1. | Overheat (red) | 8. | Reverse | |||||||||
| ||||||||||||||
|
| |||||||||||||
C. See safety instructions | 2. | Bin open (red) |
| 9. | ON/OFF (blue) | |||||||||
| ||||||||||||||
| ||||||||||||||
D. CD/Card safety flap | 3. | Bin full (red) |
| 10. Forward | ||||||||||
E. Pullout bin |
|
|
|
|
|
| 4. | Remove Paper (red) |
|
|
| |||
F. Casters |
|
|
|
|
|
| 5. SafeSense® indicator (yellow) |
|
|
| ||||
G. Disconnect power switch |
|
|
|
| 6. | Sheet capacity indicator |
|
|
| |||||
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
| ||||||||
1. | OFF |
|
|
|
|
|
|
|
|
|
|
| ||
|
| 2. | ON |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips
Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, large paper clips, laminates, file folders,
Paper shred size: |
|
5/32” x |
Maximum: |
|
Sheets per pass | 17* |
CDs/Cards per pass | 1* |
Paper entry width | 9”/230mm |
*8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 1500 sheets per day, 50 credit cards;
10 CDs. 
17 sheets per pass.
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.
•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse ( 
) to back out object.
•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.
•Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
•Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
•This shredder has a Disconnect Power Switch (G) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.
•Avoid touching exposed cutting blades under shredder head.
•Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
•For indoor use only.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
BASIC SET UP
CASTER INSTALLATION |
|
|
|
|
1 | 2 | 3 | 4 | 5 |
