Fellowes 460Ms manual Basic Shredding Operation, Advanced Product Features, Product Maintenance

BASIC SHREDDING OPERATION

Continuous operation: Up to 8-minutes maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 8-minutes will trigger

20-minute cool down period.

PAPER OR CD/CARD

1

Plug in and turn ON (I)

2	3
	or
Feed paper straight into	Hold CD/card at edge,
paper entry and release	feed right side of entry
	and release

4

When finished shredding set to OFF (O)

ADVANCED PRODUCT FEATURES

Patented SafeSense® Technology Stops shredding immediately when hands touch the paper opening.

SilentShred™ Technology SilentShred™ noise quality shreds without noisy disruptions.

SAFESENSE® TECHNOLOGY

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING
1	2	3

Turn the shredder ON	Touch test area and	SafeSense® is active and
(I) to activate SafeSense®	look for the SafeSense®	working properly
	indicator to illuminate

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

All micro-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

CLEANING AUTO-START INFRARED SENSORS

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

12

*Apply oil across entry Press and hold forward () 2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TO CLEAN THE SENSORS

1

Turn OFF (O) and unplug shredder

23 4

Locate Auto-start	Dip cotton swab in	Using cotton swab, wipe
infared sensor	rubbing alcohol	away any contamination
		from the paper sensors

Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not. operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding.