Fellowes 4800SC Checklist for Inoperative Machine, Malfunctions, Maintenance, Paper shredder

	4800SC
Paper shredder	4800CC
	C-480HS

8. Checklist for Inoperative Machine

If the equipment does not work properly, please check the following points first:

–Is the plug inserted?

–Is the switch turned on?

–Is the cabinet door closed?

–Is waste receptacle full? Empty waste bag.

–Is there a paper jam in the shredder?

–Is the motor overheated?

Switch machine off and allow motor to cool down for approximately 15–20 min.

If none of the above applies and the equipment stil does not run, please contact our customer service department.

9. Malfunctions

Motor Overheating

Red LED lights

Paper shredder switches off automati- cally.

	• Tap rocker switch pos. 2
2		➪	Rocker switch resets to zero
			position
	• Allow shredder to cool down for
		approximately 15-20 minutes.
1	•	Return switch to "on" position (1)

and continue shredding.

Cabinet door ajar / bag full

Red LED lights

Paper shredder switches off automati- cally.

Paper jam

2

Red LED lights

•Press and hold down rocker switch in pos. 2 to reverse the cutting system and back out jammed material (paper is pushed out)

	• Tap rocker switch pos. 2
2	➪	Rocker switch resets to zero
		position
	• Make sure cabinet door is properly
	closed and/or empty waste bag.
1	• Return switch to "on" position (1) and
	continue shredding.

			Caution!
			Do not attempt to force the jammed
			material through the machine by
		1	alternating the cutting system between
	2		forward and reverse
			• Remove excess paper
1			• Return switch to pos. 1 and continue
			shredding in smaller quantities so as
			not to jam the machine further

Note:

The C-480HS will not run forward again unless the jammed material has been completely removed from the throat

10. Maintenance

(Cross cut unit only)

–When shredding capacity drops or the noise increases

•Apply oil over full width of cutting cylinders through the paper entry (Fellowes Powershred Lubricant

# 35250).

CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.

1	•	Run cutting system forward and
2		backward several times without feeding
		paper
	•	Continue shredding

Edition 01/06 7