ADVANCED PRODUCT FEATURES
Jam BlockerTM | Patented SafeSense® Technology |
Blocks jams before | Stops shredding immediately when |
they start | hands touch the paper opening |
Energy Saving System
Optimal energy efficiency 100% of the time – in use and out of use.
JAM BLOCKERTM
Blocks jams before they start
1 2
If Remove Paper icon ( ) | Reduce paper quantity |
is illuminated, there is too | to an acceptable |
much paper for the shredder | amount and refeed |
to power through | into paper entry |
If Remove Paper icon illuminates during the shredding process (due to paper misfeed or wrinkle) follow the procedures below.
1 23
Shredder pauses for | Set to Reverse ( | ) | Set to Auto On ( | ) and |
3 seconds | and remove paper |
| refeed into paper entry |
SAFESENSE® TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
|
|
| |
1 | 2 | 3 | 4 |
Set to Auto On ( | ) | Touch test area and | SafeSense® is active and | If hand is held on SafeSense® |
|
| look for the SafeSense® | working properly | area more than 3 seconds |
|
| indicator to illuminate |
| shredder will shut off |
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
ENERGY SAVING SYSTEM
Optimal energy efficiency 100% of the time – in use and out of use.•Saves energy in four ways:
•Sleep Mode shuts down shredder after 2 minutes of inactivity.
WHEN IN SLEEP MODE |
|
|
|
1 | 2 |
| 3 |
|
|
| or |
In sleep mode | To get out of sleep mode | Insert paper | |
| set to OFF ( | ), then |
|
| Auto On ( | ) |
|
PRODUCT MAINTENANCE
OILING SHREDDER | FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE |
| |||
1 | 2 | 3 |
| ||
All |
| ||||
|
|
|
| ||
If not oiled, a machine may experience diminished sheet |
|
|
|
| |
capacity, intrusive noise when shredding and could ultimately |
|
|
|
| |
stop running. To avoid these problems, we recommend you | Set to OFF ( ) | *Apply oil across entry | Set to Reverse ( | ) | |
oil your shredder each time you empty your waste bin. | |||||
|
| for |
| ||
|
|
|
|
*Only use a
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not. operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, set to reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF (), then Auto On ( ) to resume shredding.