ADVANCED PRODUCT FEATURE

Turbo Jam Release™

Exclusive Turbo Jam Release™ button powers through jams

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a

machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

Cleaning Auto-Start Infrared Sensors

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

TO CLEAN THE SENSORS

1

2

3

Set to Off (O)

*Apply oil

Set to Reverse (R)

 

across entry

2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

123

Turn off and unplug

Locate Auto-start

Dip cotton swab in

shredder

infrared sensor

rubbing alcohol

4

Using cotton swab, wipe away any contamination from the paper sensors

TROUBLESHOOTING

Paper jam: Either press Reverse (R) and remove paper or follow Turbo Jam Release™ instructions below

Door open: Make sure bin is pushed in

Overheat: Wait 40 minutes for motor to cool down

Paper jam: Set to Off (O) and empty bin. Replace bin and follow the procedures below.

1

Press and hold Turbo Jam Release™ Button

23

If jam has not cleared,

Reduce paper quantity to

press and hold Reverse

an acceptable amount and

(R) for 1 second

refeed into paper entry

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs

incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

Australia Residents Only:

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.

Page 3
Image 3
Fellowes 72Ct manual Advanced Product Feature, Product Maintenance, Troubleshooting, Limited Product Warranty