3.Make sure that the BIOS setting on the connected port of your computer shows Enable. Refer to your computer documentation for the correct port configuration.
4.The cursor / trackball does not move smoothly
Remove the Trackball inset ring. Take out the trackball. Wipe the ball and the rollers with a clean,
5.The cursor moves only a small distance when the Trackball is moved
Open the “Control Panel” from “My Computer”. Select the mouse icon and proceed to the “Motion” tab, within the motion tab adjust the “Pointer Speed” and/or “Acceleration” to a faster level.
FELLOWES CUSTOMER SERVICE:
Our technical support representatives are readily available to help you with your problems. We will do our best to resolve the issue, or we will offer you full support in your decision to obtain a refund (please keep a copy of your dated sales receipt as proof of purchase).
For technical support call
FEDERAL COMMUNICATIONS COMMISSION (FCC) NOTICE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference
2.This device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installations, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.Reorient / Relocate the receiving antenna
2.Increase the separation between the equipment and receiver
3.Connect the equipment into an outlet on a circuit different from that the receiver is connected.
4.Consult the dealer or an experienced radio / TV technician for help.
