Fellowes DS-1 Basic Shredding Operation, Advanced Product Features, Oiling Shredder, Paper/Card

BASIC SHREDDING OPERATION

Continuous operation: 5-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5-minutes will trigger Ó䇓ˆ˜ÕÌiÊVœœÊ`œÜ˜Ê«iÀˆœ`°

PAPER/CARD

1

Plug in and put disconnect power Ã܈ÌV…ʈ˜Ê" Ê­q®Ê«œÃˆÌˆœ˜

2	3	4	5	6
1			or	1
Press Auto-On ( )	Check paper amount	Feed paper straight into	Feed into center of	When finished
		paper entry and release	entry and release	shredding set to OFF

ADVANCED PRODUCT FEATURES

SAFESENSE® TECHNOLOGY OPERATION

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

1 2 3

Turn the shredder ON

() to activate SafeSense®

Touch test area and	SafeSense® is active
look for the SafeSense®	and working properly
indicator to illuminate

BASIC PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1	2	3
		1

Set to Off	*Apply oil	Press and hold Reverse
	across entry	(R) 2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

PAPER JAM
1	21	13	41	5	16

Press and hold Reverse	Alternate slowly back and forth	Set to Off	Gently pull uncut paper	Press and hold
(R) 2-3 seconds		and unplug	from paper entry. Plug in.	Reverse (R)

3