GLISH

Model SB-97Cs

OPERATION

Shredder comes ready to use. Insert waste bag (Fellowes #36053) for easy disposal.

 

 

 

 

 

 

 

 

 

 

Paper entry

Safe Sense™ Technology

 

 

 

 

 

 

Sheet capacity icon

 

 

 

 

 

 

Card/CD entry

 

 

 

 

 

 

 

Shredder head

 

 

 

 

 

 

 

Sheet capacity gauge

 

 

See safety instructions below

Indicator lights (red)

 

 

 

 

 

 

 

Safe Sense™ (yellow)

 

 

 

 

 

Control switch

 

 

 

 

 

 

 

 

 

Bin open

 

 

Standby (green)

 

Bin full

 

 

 

 

 

 

 

 

 

Paper jam

 

 

 

 

 

 

 

 

 

Overheated

 

 

Auto-On (I) Off (O) Reverse (R)

 

 

 

 

 

 

 

 

 

Pullout bin

 

 

 

 

 

 

 

 

Continuous operation:

20-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 20-minutes will trigger

40-minute cool down period.

PAPER

 

 

 

Press Auto-On (I)

Feed into paper entry

 

 

 

 

 

 

and release

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CARD/CD

 

 

Set to Off (O)

 

Set to Off (O)

and plug in

Press Auto-On (I)

and unplug

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Safe Sense™

Casters

override switch

 

 

Pullout bin

Hold card/CD

Feed into card/CD entry

Slide CD cover

at edge

and release

 

Breakthrough Safety Technology! Safe Sense™ stops shredding when hands are too close to the opening. Override switch - is only needed when a jam occurs and Safe Sense™ light remains on. Warning - when switch is in override position the Safe Sense™ light flashes and the Safe Sense™ feature is rendered un-functional.

TROUBLESHOOTING

— To Test Safe Sense™ Technology

Press Auto-On ( )

 

Touch test area

 

 

 

 

 

 

 

 

CAPABILITIES

Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips

Sensor lights up

Maximum:

17*

Sheets per pass (Confetti-Cut)

Paper jam: Set to Off (O) and empty bin. Replace bin and follow any or all of the below procedures.

Press and hold

Alternate slowly back

 

Gently pull uncut paper

Press and hold

Reverse (R)

and forth

and unplug

from paper entry.

Reverse (R)

 

 

 

Plug in.

 

Note: If Safe Sense™ light remains on, you must engage override switch in order to perform above steps.

Indicator lights:

Yellow - Safe Sense™ active

Yellow flashing - Safe Sense™ not active

Make sure bin is pushed in

Wait 40 minutes for motor to cool down

Remove and empty bin

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above

Paper shred size:

 

Confetti-Cut

5/32” x 1-1/2” (3.9 x 38mm)

Cards/CDs per pass

1*

Paper width

9”/230mm

Continuous operation

20 minutes

*20lb., 8.5”x11” paper at 120v, 60 Hz, SB-97Cs–5.0Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 50-100 paper passes; 50 cards; 10 CDs.

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or immediately, if:

Follow oiling procedure below and repeat twice.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Capacity decreases

Motor sounds different, or Shredder stops running

Set to Off (O)

*Apply oil

Press Auto-On (I)

Shred one sheet

Press and hold

 

across entry

 

 

Reverse (R)

 

 

 

 

2-3 seconds

• Keep away from children and pets. Always set to off or

• Never use aerosol, petroleum based or other flammable

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair,

etc. – away from shredder openings. If object enters top

opening, switch to Reverse (R) to back out object.

• Avoid touching exposed blades under Confetti-Cut shredder head.

• Use only designated entry for cards/CDs. Keep finger away from

CD hole.

2

products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.

• 17 sheets per pass to avoid jams.

The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 7 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR

FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product.

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law.

For more details or to obtain service under this warranty, please contact us or your dealer.

3

Page 2
Image 2
Fellowes SB-97CS manual Operation, Troubleshooting, Capabilities, Warranty