Fender 40 Tuner Button, Save Button, Aux / Phones Jacks, Auxiliary Input, To use the tuner

BRONCO™ 40

Tuner Button

Your Bronco™ 40 amplifier has a built-in Tuner mode that turns the control panel LEDs into a chromatic bass tuner.

To use the tuner:

1.Press and hold the TAP button for 2 seconds. The TAP and EXIT buttons will illuminate.

2.Strike any single string on your bass and watch the panel LEDs. The Preset LEDs are used to indicate the note of the string being tuned (the top LED "#" indicates if the note is sharp).

3 LEDs indicate fine tuning. GREEN means "in tune"Letters next to LEDs indicate the note being tuned

3.Turn the tuning peg on your bass until the fine tuning LEDs above the COMP knob indicate the string is in tune, as shown above.

4.Five-string bass tuning is shown below. For four-string basses, omit the "B" string:

knob, including effect selections, is instantly recalled to your pre-programmed settings!

The SAVE button will light up red when you turn any programmable knob on the amplifier. This indicates that you have temporarily modified the preset. You can reset your modifications simply by selecting a different preset and then back again.

♫The EXIT button will not cancel changes to the current preset. Only by selecting a different preset using the PRESET knob will your temporary changes be erased.

To save a preset:

1.To save a preset you must first modify an existing preset by turning any of the programmable knobs, such as GAIN or FX. (once the SAVE button is illuminated, you can proceed to step 2).

2.Press the SAVE button. The SAVE and EXIT buttons should be flashing rapidly. You can press EXIT at this point to cancel the save process.

3.Turn the PRESET knob to select a preset to overwrite. You can only overwrite the red and green banks of the amplifier type that you started from (if you started by modifying the amber bank, you must select either the red or green bank to overwrite).

4.Press SAVE a second time to complete the save process.

♫You can modify the AMBER bank of presets by using your computer and Fender® FUSE™ software available at www.fender.com/support

5.Press EXIT or TAP to exit from the Tuner.

Save Button

Your Bronco 40 amplifier gives you the powerful ability to save every setting on the amplifier as part of a preset. When you select a preset, the level of each

Aux / Phones Jacks

Auxiliary Input
You can use the Auxiliary jack to input audio into your
Bronco 40 amplifier for accompaniment. Connect the
headphone output on your CD player or MP3 player
to the AUX jack using a mini-stereo cable. Use the		AUX
volume control on your player, together with the
MASTER volume knob, to adjust the auxiliary volume level.
Phones Jack
Plug in your headphones or ear buds to enjoy the
Bronco 40 privately. The amp's internal speaker
is muted when the PHONES jack is used. This is a
mono output.	PHONES

4 f e n d e r . c o m