LINE CORD
Your amplifier is equipped with a grounding type supply cord to reduce the possibility of shock due to electrical fault. Be sure to connect it to a grounded receptacle. DO NOT ALTER THE AC PLUG.
TUBES
The ‘63 VIBROVERB tube complement consists of two Fender Special Design 6L6WGC/5881’s (part number 039214), five Fender Special Design 12AX7A’s (part num- ber 013341), and one Fender Special Design 12AT7 (part number 023531). Fender’s Special Design Tubes provide optimum performance in this amplifier. For best results, replace with Fender original equipment tubes only. Tube location is printed on the tube label, inside the cabinet.
TOLEX COVERING CARE
The exclusive Fender Tolex covering on your cabinet is of the same material that was used on the original VIBROVERB. A very light soapy solution on a sponge may be used to remove dirt and residue that may accumulate in the grain. Be careful not to let liquid come in contact with operating surfaces. DO NOT have the amplifier plugged into a power outlet when cleaning.
TROUBLESHOOTER‘S CHECKLIST
If the amp is set up but does not function, check the following items:
•Is the amp power cord properly plugged into an electrical outlet?
•Is there power at the outlet?
•Is the fuse blown?
•Are the speakers properly connected to the amplifier?
•Is the amp on standby?
•Is the amplifier volume control turned up above “three”?
•Is the volume control on the instrument turned up?
•Is your instrument properly plugged into the amplifier? (Eliminate any effects pedals and try another guitar cord.)
If, after checking all of the above, the system is not performing
correctly, consult your Fender Service Center.
