G.PREAMP OUT jack -This jack provides an unbalanced mono output signal from the preamp. This output can be used with the POWER AMP IN jack (item H) as a patch point for mono effects devices. It can also be used to provide a signal to a recording or sound reinforcement mixer. In addition, this output can be used to drive another BXR 60 used as a slave amp. This is done by connecting a standard guitar cord from the PREAMP OUT jack of the master amplifier to the POWER
AMP IN jack (item H) of the slave.
H.POWER AMP IN jack - This unbalanced input goes directly into the power amp. It automatically disconnects the preamp when used. This jack is useful when using the effects loop feature, or when using the BXR 60 as a slave amp.
I.HEADPHONES output jack -This jack allows the use of stereo headphones for private listening. When this jack is used, the internal speaker is disconnected. WARNING:
BE CAREFUL WHEN USING HEADPHONES, AS EXCESSIVE VOLUME WILL RUIN YOUR HEARING!
J.LINE OUT jack - This quasi-balanced output is derived from the speaker, and is at line level, similar to that of the PREAMP OUT jack (item G). Since the LINE OUT jack is post-power amp, it provides a signal that is affected by the DELTACOMP™ adaptive compressor. The jack is wired TIP (+), RING (-), and SLEEVE ground. If the LINE OUT jack is used to connect to a balanced input, it will greatly reduce hum caused by a ground loop (a difference in ground potential) between the BXR 60 and another piece of equipment.
K.POWER INDICATOR - When this LED is illuminated, the BXR 60 is receiving power.
L.POWER SWITCH - turns the BXR 60 ON or OFF.
