SAFETY PRECAUTIONS
The Fender Passport sound system is supplied with a detachable power cable with an IEC female connector and a male AC connector. Depending on the territory in which the
Passport system is purchased, the power cable will be supplied with one of a number of male AC connectors to accommodate the different safety and code requirements of specific countries. All AC cables supplied with Passport products are three pin grounded types.
Under no circumstances should the ground (earth) pin be disconnected or removed.
Your Passport System features a
When traveling abroad with the Passport system, as a standard precaution, always check the local voltage and set the voltage selector switch located adjacent to the power input socket on the rear of the mixer / amplifier to the appropriate operating range. This check must be performed before connecting the power cable. The Fender Passport has two range settings: 115 V or 230 V.
Failure to select the appropriate voltage range will cause the unit to go into protect mode, void any warranty and may cause damage to the unit.
For example, The United States of America is standardized at 117 volts / 60 Hz, Japan operates on 100 volts / 50 Hz. For both of these countries the range selector must be set to 115 V. Countries in the EEC have standardized at 230 volts / 50 Hz., however, there are different types of AC plugs used. For all these countries the selector should be at the 230 V position. When using plug adapters or operating in a territory other than the one in which the unit was purchased, take great care to comply with local safety requirements and electrical codes of practice.
If you are not sure of the local voltage, wiring codes & colors, AC grounding, or correct procedures for connection, consult a qualified technician.
Warning
Under no circumstances should the ground pin on the Passport or on any of your electrical equipment be lifted (cut off or disconnected). By following the correct procedures and safety
precautions, risks of severe shock hazard can be mini- mized. Best of all, avoid operating the system in con- junction with ungrounded or improperly grounded electrical equipment.
TRANSPORTATION LATCHES
To open and close your Passport system, simply follow these guidelines:
1.Place your finger tip under the safety latch and gently lift. When the safety latch has disengaged, lift the main latch to remove the speaker.
2.To replace, position the speaker on the tower foot and bring the speaker in to close the engagement with the tower and latch. Position the latch hook over the speaker notch and close the latch. The safety latch will automa- tically engage.
Note: These parts are precision engineered and no force is needed to secure them. Careful alignment of parts will ensure easy operation.
4
