Bullet / Bullet Reverb Front Panel Functions
A | B | C D E |
F |
G | H | I |
J | K | L | M |
A.INPUT - A high impedance, high sensitivity
B.NORMAL VOLUME - Adjusts the overall loudness of the Normal Channel.
C.GAIN - Adjusts the amount of preamp amplification in the Drive Channel. Cleaner sound is achieved at lower gain settings; high gain settings will produce more sustain and distortion. This control works in conjunction with the DRIVE VOLUME control (item E) to set the overall loudness of the Drive Channel.
D.DRIVE SELECT - Activates the Drive Channel.
E.DRIVE VOLUME - Adjusts the overall loudness of the Drive Channel.
F.TREBLE - Adjusts the amount of boost or cut in the high frequency range.
G.MID - Adjusts the overall tone quality without affecting the signal level. High MID settings will provide emphasis in the midrange frequencies whereas a lower setting will notch the midrange to produce sounds characteristic of most “metal” music.
H.BASS - Adjusts the amount of boost or cut in the low frequency range.
I.REVERB - ( BULLET REVERB ONLY.) Adjusts the amount of reverberated signal mixed with the original dry signal for both the Normal and Drive channels.
J.EXTERNAL SPEAKER - This jack provides an output to an external speaker enclosure. The enclosure must have a minimum impedance of 8Ω Use of this jack automatically disables the internal speaker. DO NOT PLUG HEAD PHONES IN HERE.
K.HEADPHONES - This jack provides an output to standard stereo or mono headphones for private listening. NOTE: Use of this jack automatically disables the speaker. CAUTION: Prolonged listening at high levels may be hazardous to your hearing! This jack can also be used as an unbalanced line output by using either a stereo or mono 1/4 inch phone plug connection.
L.POWER INDICATOR - When this indicator is illuminated the Bullet / Bullet Reverb is receiving AC power.
M.POWER SWITCH - This switch turns the AC power ON and OFF. When the switch is OFF the amplifier is completely shut down.
LINE CORD - This amplifier is equipped with a grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded receptacle. DO NOT ALTER THE AC PLUG.
