Fender Twin Amplifier owner manual Specifications

Specifications

PART NUMBER:

TYPE:

DIMENSIONS:

POWER REQUIREMENT:

FUSE TYPE:

INPUT IMPEDANCE:

EFFECTS LOOP:

EFFECTS MIX CONTROL:

REVERB:

PRE-AMP OUT:

POWER AMP IN: BALANCE LINE OUTPUT:

AMPLIFIER LOAD IMPEDANCE:

POWER OUTPUT: into 4, 8 or 16 ohms.

SPEAKER COMPLEMENT:

120V version: 21-4809

230V version: 21-4889

PR 266

Height: 20-3/4” (52.7 cm)

Width: 26-3/8” (67 cm)

Depth: 11-1/2” (29.2 cm)

Weight: 77 lbs. (35 kg)

120V version: 120 volts AC, 60 Hz, 360 watts.

230V version: 230 volts AC, 50 Hz, 360 watts.

100V and 120V versions: 4A SLO-BLO, 125V min.

230V and 240V versions: T2A, 250V.

Input 1: 1M ohm.

Input 2: 136k ohm.

Pre reverb.

Nominal level: +2, -5.5, -13 dBV.

Output impedance: 4.2k ohm maximum.

Input impedance: 130k ohm minimum.

Continuously variable between the signal at the EFFECTS SEND and EFFECTS RETURN jacks.

Post effects loop.

Post reverb, +1.3 dBV nominal level.

Recommended load: 22k ohm minimum.

+1.3 dBV sensitivity, 130k ohm input impedance.

Derived from the output transformer, fully balanced. +3 dBV nominal level into 600 ohms or greater. Pin 1 floating, pin 2 (+), pin 3 (-).

Switch selectable for 4, 8, or 16 ohms.

OUTPUT HIGH setting: 100 watts RMS, 5% THD.

OUTPUT LOW setting: 25 watts RMS, 5% THD.

Two Fender P/N 026488 Special Design 12” 8 ohm speakers wired in series.

A PRODUCT OF:

FENDER MUSICAL INSTRUMENTS CORP.,

CORONA, CA 91720

MADE IN U.S.A.