Operating
the Zero Turn Rider
GENERAL OPERATING SAFETY
Before first time operation:
•Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower.
•Become familiar with all of the controls and how to stop the unit.
•Drive in an open area without mowing to become accustomed to the unit.brake pedal or set the park- ing brake.
CHECKS BEFORE STARTING
•Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.
•Make sure all nuts, bolts, screws and pins are in place and tight.
•Adjust the seat position, and make certain you can reach all controls from operator’s position.
•Fill the fuel tank with fresh fuel. Refer to engine man- ual for fuel recommendations.
WARNING
Never allow passengers to ride on the unit.
Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.
To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do not stop or park tractor over dry leaves, grass or combustible materials.
Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid
DANGER
B | A | C |
Figure 2. Pre-start Checks
A.Fuel Tank Filler Neck
B.Crankcase Oil Fill
C.Seat Adjustment Lever
OPERATING ON SLOPES CAN BE
DANGEROUS
Never operate on slopes greater than 30 percent (16.7°) which is a rise of three feet vertically in 10 feet horizontally.
Operate the unit at a slow ground speed when driving onto slope.
Use extra caution when operating on slopes with
10 | 00 |
