Ferris Industries 5901179, 5901180, 5901181 manual Servicing The Mower Blades, Regular Maintenance

SERVICING THE MOWER BLADES

1.Blades should be sharp and free of nicks and dents. If not, sharpen blades as described in following steps.

2.To remove blade for sharpening, use a 1” wrench on the flats of the spindle shaft while removing the blade mounting bolt with a 15/16” wrench (Figure 28).

3.Use a file to sharpen blade to fine edge. Remove all nicks and dents in blade edge. If blade is severely damaged, it should be replaced.

4.Balance the blade as shown in Figure 29. Center the blade’s hole on a nail lubricated with a drop of oil. A balanced blade will remain level.

5.Reinstall each blade with the tabs pointing up toward deck as shown in Figure 30. Secure with a bolt and flat washer and torque bolts to 70 ft.lbs. (94 N.m.).

WARNING

Mower blades are sharp. For your personal safety, do not handle mower blades with bare hands. Careless or improper handling of blades may result in serious injury.For your personal safety, blade mounting bolts must each be installed with a flat washer then securely tightened. Torque blade mounting bolts to 70 ft.lbs. (94 N.m.)

Regular Maintenance

Figure 28. Removing the Blade

Nail

Figure 29. Balancing The Blade

A

Figure 30. Installing The Blade

A.Blade Bolt

B.Flat Washer

Maintenance

37