Festool Technical data ETS 125 Q / ETS 125 EQ, Symbols, Electrical connection, Operation

f)Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.

g)Use the power tool, accessories and tool bits etc., in accordance with these instruc- tions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.

5)Service

a)Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.

TO REDUCE THE RISK OF INJU- RY, USER MUST READ AND UNDERSTAND INSTRUCTION MANUAL.

Various dust created by power sand- ing, sawing, grinding, drilling and other construc- tion activities contains chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

•Lead from lead-based paints,

•Crystalline silica from bricks and cement and other masonry products,

•Arsenic and chromium from chemically-treated lumber.

The risk from these exposures varies, depending on how often you do this type of work.

To reduce your exposure to these chemicals work in a well ventilated area and use approved safety equip- ment, such as dust masks that are specially designed to filter out micro- scopic particles.

Technical data		ETS 125 Q / ETS 125 EQ
Wattage		230 W
No load speed		15 000 rpm / 6 000 - 15 000 rpm
No. of strokes		30 000 spm / 12 000 - 30 000 spm
Sanding stroke		2.0 mm (0.079 in.)
Sanding base (delta form)		Ø 125 mm (4.9 in.)
Weight		1.1 kg (2.4 lbs.)
Safety llevel		/ II
			reasons. The machines may only be used for dry
	Symbols
			sanding.
V	volts
				The user bears sole responsibility for
A	amperes
			any damage or accidents resulting from incorrect
Hz	hertz
			use.

Wwatt

~	alternating current	Electrical connection
		and operation
n0	no load speed
		The mains voltage must correspond with the
	Class II Construction
rpm	revolutions per minute	voltage on the rating plate!
		See the following figure for connecting or
spm	strokes per minute
		disconnecting the power cord of the tool.

Intended use

The sanders are designed for sanding wood, plastic, composite materials, paint / varnish, filling material and similar materials. Metal and materials with an asbestos content must not be processed with these tools.

The machine is particularly suitable for processing smaller surfaces and overhead work because of its size, its weight and its output.

The machines must not be damp nor operated in a damp environment for electrical safety

Always switch the machine off before connecting or disconnecting the power cable!

3