Installation
STEP4. Level the unit from left to right and front to back.
-Adjustthe unit down by lifting up on the buckle.
-Adjust the unit up by pulling down vertically on the Hand
Loops while lifting up the bottom of the cabinet.
Location
Installthe unit in a heated space that provides convenient space for
serviceaccess. A typical location is in either a mechanical room or
anarea close to the outside wall within close proximity to where
theweatherhoods are mounted. If a basement area is inconvenient
ornon- existent, install the unit in a utility or laundry room.
Atticinstallations are not recommended due to:
A)the complexity of work to install
B)freezing conditions in the attic
C)difficulty of access for servicing and cleaning
Leavesufficient clearance at the front of the access door for
servicingthe air filters and core. The recommended clearance is a
minimumof 25" (635 mm) for opening and closing the door. Field
Controlsprovides four straps for hanging the unit from the
basementfloor joists.
HandLoops
Buckles
Pulldownon the hand
loopswhilelifting
thebottomof the unit.
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, personal injury or loss of life.
Installation and service must be performed by
a qualified installer or service agency.
WARNING
Unit must be installed lev el to ensure proper
condensate drainage. Due to the broad range of
installation and operational conditions, consider
the possibility of condensation forming on either
the unit or connecting ducting. Objectsbelow the
installation may be exposed to condensate.
CAUTION
HandLoops
Screws(not included)
Buckles
Joist
Washers(not included)
HangingStrap grommets
“S”hooks
Note:Thisillustration of the unit may
varyfrom the unit you are installing.
DETAIL
Suspend the Unit with the Adjustable Hanging Straps
STEP1. Insertthe screws and washers (not included) through
theHanging Strap grommets and fasten to the joists.
STEP2. Unscrew the 4 machine screws located on the upper
sideof the unit. Attach the "S" hooks and reinsert the machine
screws.
STEP3. Hook the bottom grommets of the straps through the "S"
hooks.Pull down vertically on the hand loops while lifting up the
bottomof the cabinet. Repeat at opposite end of the unit.
Hand Loops
Straps
STEP5. Foldthe hand loops and excess strap and secure with a
nylontie (not included).
Use 4 screws and 4 washers (not incldued) to attach the hanging
straps to the floor joists. The washer must be wider than the eyelet
ofthe grommet on the hanging strap.
By design, the adjustable hanging straps reduce the possibility of
noise,resonance, and harmonics.
Note:Do not pull the
HandLoops in a
horizontalor lateral
directionduring the
installation/adjustment
process.
17