Field Controls UV-18HPC, UV-28C, UV-18C, UV-12HPC I.Indication For Use, Ii.General Information

I.INDICATION FOR USE

This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigation, treatment, or prevention of any disease or condition.

II.GENERAL INFORMATION

There are different size units available, depending on the square footage of your home. See chart below for determining your homes needs.

	Minimum										Max Air	Lamp Intensity at 1		Recommended
Model	Duct		Volts		Amps		Hz		Watts
											Temp °F	meter		Max Sq. Feet
	Width
UV-12C	9	120		0.5		60		30		190°		37 μW/cm2	1500
UV-18C	14	120		0.5		60		30		190°		73 μW/cm2	2000
UV-28C	22	120		1.1		60		60		150°		105 μW/cm2	3000
UV-28	22	120		1.1		60		60		150°		105 μW/cm2	3000
UV-12HP	9	240		0.5		60		30		190°		37 μW/cm2	1500
UV-18HP	14	240		0.5		60		30		190°		73 μW/cm2	2000
UV-28HP	22	240		1.1		60		60		150°		105 μW/cm2	3000
UV-12HPC	9	240		0.5		60		60		190°		37 μW/cm2	1500
UV-18HPC	14	240		0.5		60		30		190°		73 μW/cm2	2000
UV-28HPC	22	240		1.1		60		30		150°		105 μW/cm2	3000

The UV-12C,18C,28C,12HPC,18HPC, and 28HPC units are equipped with a circuit board to monitor the operation of the UV lamp; it indicates the operation of the lamp through an LED indicator light mounted on the cover of the unit. The circuit board indicates good operation of the lamp by a continuous “GREEN” color on the LED light. After 8,320 hours of lamp operation, the circuit board indicates the elapsed time of lamp operation by a continuous “YELLOW” color on the LED light and the internal alarm will beep every 15 minutes. After 9,000 hours of lamp operation, the circuit board indicates the elapsed time of lamp operation by a continuous “RED” color on the LED light and the internal alarm will beep every 5 minutes. The board also checks if the UV lamp is burned out. If the lamp is burned out, the circuit board will indicate this by a continuous “RED” color on the LED and the internal alarm will beep every 5 minutes.

WARNING: Before installing or servicing a humidifier, air filter, heat system, or this unit, etc., always turn all power OFF and have unit unplugged. Electrical shock can cause personal injury or death. Never expose eyes or skin to direct UVC light from any source.

WARNING: To prevent water damage or electric shock, do not mount unit under a humidifier.

WARNING: Designed for a closed duct system. Do not mount near a supply or a return air opening.

WARNING: This product is designed for indoor installation only (i.e. attics, crawl spaces, basements, etc.). For use on gas fired, oil fired, electric and split system heat pump forced air systems*. This product is NOT designed to be mounted outside on gas fired or heat pump packaged units**.

*Split system heat pumps are systems where the air handler and the air conditioning compressor are separate units.

**Packaged units are systems where the air handler and the air conditioning compressor are built together and are installed outside of the building

WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your

hands. Page 2