Field Controls UV-28HPC, UV-18HPC, UV-28C, UV-18C Plug ballast plug into end of lamp. See Figure

8.Insert lamp through the hole until lamp cannot be inserted any further. (See Figure 16)

9.Swing the swivel bracket over the end of lamp. Hand-tighten the wing nut on the stud. Be careful no to over tighten the wing nut. The porcelain at the lamp base may crack when over tightened. (See Figure 17)

Figure 16

Figure 17

10. Plug ballast plug into end of lamp. (See Figure 18)

Figure 18

11. Snap cover onto the unit base. (See Figure 19)

Figure 19

12. Plug the LED wire from the cover onto the board. (See Figure 20)

Figure 20

WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your

hands. Page 6