LIGHTING
Prior to lighting yourbarbeque,visually check all hoses before each
use for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, DO NOT USE YOUR BARBEQUE. A replacement hose and regulator is required (see ‘PARTS LIST ’ in Assembly Brochure).
IMPORTANT
•Always raise the barbeque lid before lighting.
•Do not lean over the barbeque when lighting the burner.
•Visually check the flames every time you light your barbeque (Figure 10). If the flame is abnormally small or a smoky yellow
! | IF LIGHTING MAIN BURNERS ONLY, | |
| ||
CAUTION | ENSURE SIDE BURNER KNOB IS IN THE OFF | |
POSITION. | ||
|
HIGH
LOW
Fig. 10
MAIN BURNERS
USING THE IGNITOR (Figure 11A)
1.Open the lid before lighting.
2.Turn off all of the burner control knobs and close the gas supply valve.
3.Open the gas supply valve and wait 5 seconds.
4.Push in and turn a single main burner control knob to ‘HIGH’.
All other control knobs should be in the "OFF" position. 5.Depress the ignitor, repeat if necessary.
6.If the burner does not light immediately (within five seconds), turn burner control knob off and wait 5 minutes to clear the gas.
7.Repeat steps 1 to 6. If burner still fails to light, refer to Troubleshooting Guide to determine cause and solution, or try the Match Lighting procedure (Fig. 11B).
1.
Fig. 11A
LIGHTING THE OTHER MAIN BURNERS
Once one burner has been lit, push in and turn the adjacent control knob to ‘HIGH’. The unlit burner will light automatically.
4.
5.
MATCH LIGHTING PROCEDURE
1.Open the lid before lighting.
2.Place an ignited lighter or lit match through the lighting hole, approx. 1.25 cm (1/2") from burner. (See Figure 11B)
3.Push in and turn the left burner control knob to ‘HIGH’. The burner should light immediately (within five seconds). If it does not, extinguish the lighter or match, turn the control knob to off, and wait 5 minutes to clear the gas.
4.Repeat steps 1 to 3. If burner fails to light, refer to the Troubleshooting Guide to determine cause and solution.
5.Once left hand burner is lit, light remaining burners in this sequence: center burner, then right burner.
LIGHTING THE OTHER MAIN BURNERS
Once one burner has been lit, push in and turn the adjacent control knob to ‘HIGH’. The unlit burner will light automatically.
BURNER
MATCH
MATCH
LIGHTING
HOLE
Fig. 11B
10
