LIGHTING INSTRUCTIONS
NOTE: Turn on one valve at a time for either automatic or manual lighting. Adjacent barbecue burner will
5.Push either gas valve and turn to ‘HIGH’ then immediately use the spark generator to ignite your burners (see Figure 11).The burner should light.
CAUTION: If the burners do not light, IMMEDIATELY turn the valve to ‘OFF’ and WAIT 5 MINUTES before repeating step 5. If the burners still do not light, refer to the instructions for ‘Manual Lighting’ to the right.
CAUTION: Always wait 5 minutes for gas to clear after any unsuccessful lighting attempt.
1.Follow steps 1 through 4 above.2.Insert either a burning
3.While holding the match or lighter flame next to the burner, depress the appropriate valve knob and turn it counterclockwise to the ‘HIGH’ position. Adjacent burners will
4.If the burner does not light, IMMEDIATELY turn the valve to ‘OFF’ and WAIT 5 MINUTES before repeating steps 2 through 4 of these instructions.
Figure 12 - Match Holder
REMEMBER: FOR SAFE MANUAL LIGHTING, PLACE A BURNING MATCH OR BUTANE LIGHTER BESIDE THE BURNER - THENTURN ONTHE GAS (Figure 13).
NOTE: Barbecues frequently achieve a better air/gas mixture and will ignite more quickly if the valve is first turned beyond ‘HIGH’ to ‘MEDIUM’ or ‘LOW’ for lighting.
READ SETTING
HERE
|
|
| F |
|
| F | |
|
| O |
|
|
| N |
|
| R |
| |
U |
|
| |
T |
|
|
|
O |
|
|
|
T |
|
|
|
OFF
LOW
T | |
O | |
| T |
| U |
| R |
| N |
| O |
| N |
L | HIGH TO |
IGHHI | LIGHT |
T |
|
4.If the odor continues, immediately call your gas supplier or fire department.
Figure 11 - Valve Control Knob | Figure 13 - Manual Lighting |
|
PROBLEMS & TROUBLESHOOTING
If you have trouble with your Fire Magic Gas Barbecue, please use this list to identify the problem. By trying one or more of the solutions to the possible cause you should be able to solve the problem. If this list does not cover your present problem or you have other technical difficulties with the barbecue, please contact your local Fire Magic dealer or visit our website at www.rhpeterson.com
PROBLEM |
| POSSIBLE CAUSE |
| CORRECTION | |
|
|
|
| ||
| 1) Improper air shutter adjustment. | 1) Adjust air shutters (see Page 5) | |||
|
|
| |||
| 2) | Ignition wire disconnected | 2) | ||
Ignition System Failure |
|
| |||
3) | Low gas pressure | 3) | Have Gas Co. check the operating pressure at | ||
| |||||
|
| the barbecue | |||
|
|
|
| ||
| 4) | Dead Battery | 4) | Replace battery (see Page 6) | |
|
|
| |||
|
|
|
|
| |
| 4) | Improper air shutter adjustment | 4) | Adjust air shutters (see Page 5) | |
Insufficient Heat | 5) | Using Propane orifice for Natural Gas | 5) | Change orifices (see Page 4) | |
|
|
|
| ||
| 6) | Low Gas Pressure | 6) | Have Gas Co. check the operating pressure at | |
|
|
|
| the barbecue | |
|
|
|
|
| |
| 7) | Burner ports partially blocked by debris | 7) | Remove burners (see Page 4) clean out ports | |
Uneven heating | 8) | Small spiders or insects in burner | 8) | Inspect burners and orifices (see Page 4) for | |
|
|
| spider webs or other debris that may block flow | ||
|
|
|
| ||
| 9) | Improper Air Shutter adjustment | 9) | Adjust air shutter (see Page 5) | |
|
|
| |||
Rotisserie Noisy | 10) Rotisserie out of balance | 10) Adjust rotisserie counterbalance | |||
|
|
|
|
|
8