DOUBLE SIDEBURNER

SAFETY

The right knob controls the front burner and the left knob controls the back burner.

of this grill. Each sideburner must have the correct gas oriÞ ce for the grill to operate safely and effectively as it was designed.

CAUTION: THE SIDEBURNER MUST COOL DOWN BEFORE HANDLING OR ADJUSTMENT.

Do not operate the sideburner with the cover closed.

Be sure the sideburner has good ventilation, is free of debris, and is away from ß ammable substances before lighting.

Properly burning ßames are mostly blue with yellow tipping and are steady and spread evenly around the burner.

5.Replace the burner caps so that they are centered over their respectiveburnerswith the slightly rounded part of the burner cap pointing upward. The notches in the burner cap must Þ t over the studs protruding from the burner base for the cap to be properly seated.

Fig. 36-2 Positioning

the Burner Cap

STAINLESS STEEL SIDEBURNER COVER

Note: The cover is free-standing and is not hinged in the back.

To remove the cover, carefully lift off using the built in handle.

To replace the cover, put the back of the cover into position against the back inner lip of the sideburner grill rest and then lower the front into position so that it covers the side burner opening entirely.

ORIFICE CHECKING

1.Remove the cover and then the grid. Set them aside.

2.Lift the brass burner

caps

off of

both

Fig. 36-1

front

and

back

 

sideburners and

 

set them aside.

 

3.Look down into the hole at the center

o f t h e bu r n e r, using a flashlight

if necessary, and read the number stamped on the top of the brass gas oriÞ ce (see Fig. 36-1).

4.Compare the number with the orifice size information for your gas type in the MODEL SPECIFICATIONS TABLE under the gas type

6.Replace the gr id and the cover as appropriate.

ORIFICE CONVERSION

1.Follow steps 1. and 2. under ORIFICE CHECKING.

2.Pull the metal tube up out of the center of each burner, taking note of the upper end that has the lip on it. Set it aside.

3.Use a 15/16" wrench to carefully loosen and then remove the brass nut holding each burner in place and set it aside.

4.Remove the burner control knobs from the face plate by pulling them gently away from the face plate. Set them aside.

5.Pull the wood-chip drawer completely out from the front of the grill and set it aside.

6.Remove the faceplate from the front of the grill by unscrewing the screws on the left and right sides using the Phillips-head screwdriver and then lifting the faceplate Þ rst upward so that it clears the Òlid closedÓ switch on the left side and then shift it to the right until it is free of the grill. Gently lower the top of the faceplate until it rests securely by the internal chain with itÕs base resting against the grill.

7.Reach into the space underneath the double side burner and pull out each brass burner in turn carefully bending the ß exible metal tubing still attached.

36