DOUBLE SIDEBURNER
8.Replace the oriÞ ce using a 3/8" hex nut driver.
Note: It will help to start the brass oriÞ ce with your Þ ngers to avoid cross threading it.
9.Replace each brass burner by bending the connected metal tubing back into place so that the threaded top of the burner sticks through
from underneath the burner hole and screw it in using the brass nut and the 15/16" wrench.
Important: Do not over tighten.
10.Follow steps 5 and 6 under ORIFICE CHECKING.
ADJUSTING THE FLAME
Height of the ß ame with a valve in low position may be further regulated by means of a small adjusting screw in the center of the valve stem.This screw is accessible by removing the valve knob which pulls straight off the end of the valve stem.
Turn the screw to the right to reduce the ß ame height at the low setting and to the left to increase it.
Note: The double sideburner has no
37