2 0Optional Equipment
Temperature Meter
The temperature meter displays the temperature of the combustor, allowing the operator to monitor combustor
Condar Company
P.O. Box 250
108 Mill Spring Road
Columbus, NC
(828)
Model:
1Before installing the faceplate, route the thermocouple wire to the catalytic combustor (see the illustration below). With the wire in place, the faceplate can be installed.
|
|
|
|
|
|
|
|
|
|
|
|
c |
|
|
|
|
|
Run | the wire through this |
|
| ||
notch |
|
|
|
| |
|
|
|
|
| |
| NOTE: if the notch is not |
|
| ||
| present, file a notch in the |
|
| ||
| arched piece of metal) |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
a | Remove this screw and pass the |
soldered end of the included | |
| thermocouple wire through the hole. |
| NOTE: if the hole is not present, drill a |
| 1/8" diameter hole (drill frominside the |
| firebox). |
| 5/16" |
b | Insert the soldered end of the wire into the |
catalytic combustor approximately 1/2" |
Route the wire along the outside of the d firebox assembly, behind the location
where the face attaches (either side). Tuck excess wire to the side so it does not contact the firebox.
Attach the molex connector from the wire to the |
|
e | Temp Meter |
wire so it exits below the faceplate. |
|
NOTE: If the connector is not present, connect the wires to the two posts on the back of the temp meter. The yellow inner wire goes to the positive (+) pole.
Travis Industries | 9 3 5 0 8 0 9 1 | 2 2 0 6 0 2 |