Programming Preparation
Step 1. Installing Batteries
The digital keypad is powered by 4 “AA” batteries which must be installed before you can begin programming your personal code. For your convenience, we have provided you with 4 “AA” batteries. For best results and depending on use, we recommend replacing the batteries at least once a year.
1.Locate battery compartment to the right of the digital keypad.
2.To open the compartment, press firmly in on the battery cover and slide it to the right for removal.
3.Install 4 new “AA” batteries in the battery compartment. Make sure they are installed in the correct direction as marked on the inside of the battery compartment.
4.Once the batteries are installed properly, replace the cover by sliding it back on from the left.
Important: BATTERY REMOVAL
If the batteries are removed or fail, the keypad memory will NOT be erased.
BATTERY
COMPARTMENT
Step 2. Open Safe with Override Key (square top)
You will need access to the inside of the safe door to begin programming. You must use the Emergency Override Key (square top) to open the door for the first time.
1. Insert the Emergency Override Key (square top) in the
lock, turn to the left (counterclockwise) and pull the door open.
Important: TURN OVERRIDE KEY TO LEFT ONLY
When using the Emergency Override Key, you must ONLY TURN IT TO THE LEFT. Turning it to the right may cause key to become stuck in the cylinder and may cause damage to the lock.
2
