UNDERSTANDING YOUR CO ALARM

WHAT YOU SEE AND HEAR DURING INSTALLATION

WHEN YOU FIRST PLUG-IN THE CO ALARM:

HORN: Silent

POWER/ALARM LIGHT: Shines continuously

UNDER NORMAL CONDITIONS (AC POWER):

HORN: Silent

POWER/ALARM LIGHT: Shines continuously

WHEN YOU TEST THE CO ALARM:

HORN: Sounds loudly - 4 beeps, pause, 4 beeps, pause

POWER/ALARM LIGHT: Flashes rapidly

WHAT YOU SEE AND HEAR UNDER DIFFERENT CONDITIONS:

WHEN THE ELECTRICITY COMES BACK ON AFTER A POWER FAILURE:

HORN: Silent

POWER/ALARM LIGHT: Shines continuously.

IF THE CO ALARM IS NOT OPERATING PROPERLY (MALFUNCTION SIGNAL):

HORN: Three rapid chirps every minute

POWER/ALARM LIGHT: Flashes three times in sync with the horn.

WHAT YOU SEE AND HEAR IF CO IS DETECTED:

ALARM LEVELS OF CO ARE DETECTED:

HORN: Sounds loudly - 4 beeps, pause, 4 beeps, pause. This sequence repeats for as long as the unit is in alarm.

POWER/ALARM LIGHT: Flashes rapidly

IF YOU SILENCE THE ALARM:

HORN: Silent for about 4 minutes

POWER/ALARM LIGHT: Flashes rapidly

Note: After 4 minutes, if CO levels drop below alarm levels, the unit will remain silent and return to normal operation. If CO presence still indicates a potentially dangerous situation, the horn will sound again.

IF THE CO LEVELS RETURN TO NORMAL:

HORN: Silent

POWER/ALARM LIGHT: Shines continuously

WHERE CO ALARMS SHOULD NOT BE INSTALLED

DO NOT LOCATE THIS CO ALARM:

•In garages, kitchens, furnace rooms, or in any extremely dusty, dirty or greasy areas.

•Closer than 15 feet (4.6 meters) from a furnace or other fuel burning heat source, or fuel burning appliances like a water heater.

•Within 5 feet (1.5 meters) of any cooking appliance.

•In extremely humid areas. This Alarm should be at least 10 feet (3 meters) from a bath or shower, sauna, humidifier, vaporizer, dish- washer, laundry room, utility room or other source of high humidity.

•In areas where temperature is colder than 40˚ F (4˚ C) or hotter than 100˚ F (38˚ C). These areas include non-airconditioned crawl spaces, unfinished attics, uninsulated or poorly insulated ceilings, porches, and garages.

•In turbulent air, like near ceiling fans, heat vents, air conditioners, fresh air returns, or open windows. Blowing air may prevent CO from reaching the sensors.

•In direct sunlight.

•In outlets covered by curtains or other obstruction.

•This CO Alarm is designed for use inside a single-family home or apartment. It is not meant to be used in common lobbies, hallways, or basements of multi-family buildings unless work- ing CO Alarms are also installed in each family living unit.

CO Alarms in common areas may not be heard from inside individual family living units.

•This CO Alarm alone is not a suitable substitute for complete detection systems in places which house many people, like hotels or dormitories, unless a CO Alarm is also placed in each unit.

•DO NOT use this CO Alarm in warehouses, industrial or com- mercial buildings, special-purpose non-residential buildings, or airplanes. This CO Alarm is specifically designed for residential use, and may not provide adequate protection in non-residential applications.

INSTALLATION

WHERE TO INSTALL CO ALARMS

The National Fire Protection Association (NFPA) recommends that a CO Alarm should be centrally located outside of each separate sleeping area in the immediate vicinity of the bedrooms. For added protection, install additional CO Alarms in each separate bedroom, and on every level of your home.

If your bedroom hallway is longer than 40 feet (12 meters), install a CO Alarm at BOTH ends of the hallway.

BEDROOM

BEDROOM

BEDROOM

 

KITCHEN

 

LIVING ROOM

HALL

 

 

BASEMENT

 

REQUIRED TO MEET NFPA RECOMMENDATIONS SUGGESTED AREAS FOR INSTALLING ADDITIONAL CO ALARMS

In a Single-level Home:

•Install at least one CO Alarm near or within each separate sleeping area.

•For added protection, install an additional CO Alarm at least 20 feet (6 meters) away from the furnace or fuel burning heat source.

In a Multi-level Home:

•Install at least one CO Alarm near or within each separate sleeping area.

•For added protection, install at least one CO Alarm on each level of the home.

•For added protection, install an additional CO Alarm at least 20 feet (6 meters) away from the furnace or fuel burning heat source.

This unit should receive continuous electrical power. Choose an outlet where it cannot be accidentally unplugged or switched off by children. Keep small children away from the unit. Teach them not to play with it or unplug it. Explain what the alarms mean.

2

Page 1 Page 3
Page 2
Image 2
First Alert CO600 user manual Installation, Understanding Your CO Alarm, Where CO Alarms should not be Installed
Page 1 Page 3

CO600 specifications

The First Alert CO600 Carbon Monoxide Detector is an essential safety device designed to protect homes and families from the dangers of carbon monoxide (CO) poisoning. This compact and efficient detector features advanced technology aimed at providing timely alerts in the event of hazardous CO levels in the air.

One of the standout features of the CO600 is its reliable electrochemical sensor, which is known for its accuracy in detecting even low levels of carbon monoxide. This type of sensor is sensitive and responds quickly to changes in CO concentration, ensuring that occupants are notified well in advance of any potential dangers.

The CO600 comes equipped with a digital display that continuously monitors CO levels in real-time. This display allows users to track CO concentration and take necessary actions if levels become unsafe. Additionally, the device features a peak level memory that stores the highest concentration of carbon monoxide detected, enabling users to review exposure levels over time.

In terms of installation, the First Alert CO600 is designed for easy use. It can be conveniently mounted on a wall or placed on a tabletop, making it versatile enough for various room configurations. The unit operates on a standard 120-volt power source, and it includes a battery backup to ensure continued operation during power outages.

Another vital characteristic of the CO600 is its sound alarm, which emits a loud 85-decibel alert when dangerous levels of carbon monoxide are detected. This loud alarm ensures that users will hear it even while sleeping, providing peace of mind in knowing that prompt alerts are in place.

The First Alert CO600 is also equipped with a test/silence button, allowing users to easily test the unit’s functionality and silence false alarms as needed. This is particularly useful in households where cooking or other activities might inadvertently trigger the alarm.

For those concerned about longevity, the CO600 comes with a lifespan of approximately seven years, which is typical for most carbon monoxide detectors. At the end of its life, the unit provides a clear end-of-life signal, prompting users to replace the device.

Overall, the First Alert CO600 carbon monoxide detector blends reliability, ease of use, and advanced sensing technology to deliver essential protection against the silent threat of carbon monoxide poisoning, making it a valuable addition to any home safety plan.
Top Page Image Contents